Code 11 Selection - Welch Allyn SCANTEAM 3210 Series Operating Manual And Programming Menu

Code 11 Selection

Scan the bar code below to start Code 11 symbology
selection, then enable or disable Code 11 decoding.
Note: If you don't need to program additional selections, you may
scan EXIT now to exit program mode and save your changes.
To set minimum allowable length, scan the "Set Minimum
Length" bar code, then refer to the Industrial Symbologies
Min/Max Length chart (page 3–47). Scan two of the Numeric
Bar Codes (below the Length chart) to set the length. Repeat
the process to set maximum length.
Other Code 11 selections include: 2 Check Digits
3–42 Additional Programming
ENTER Program Mode
Code 11 Selection
Enable (Yes )
Disable (No)
Set Minimum Length
Set Maximum Length
Required?.