Format Selection - Welch Allyn SCANTEAM 2380 WAND Programming Menu Manual

SCANTEAM 2380 Programming Menu
USE THIS PAGE
To select the pre–programmed asterisked (*) values by scanning DEFAULT symbol.
To add preambles and/or postambles to the bar code.
To select function transmit enable.
To select keyboard type.
To set intercharacter, interfunction, and intermessage delays to specific values.
To control scanning indicators or enable function records feature.
scan
To enable the Append Buffer when Code 3 of 9 with append option is enabled.
selections
PREAMBLE (3)
ENTER
(up to 5 chars max)
POSTAMBLE (4)
scan
(up to 5 chars max)
FUNCTION XMIT
KEYBOARD TYPE
DEFAULT
INTERCHARACTER
DELAY
INTERFUNCTION
DELAY
INTERMESSAGE
DELAY
BEEPER (5, 6)
APPEND BUFFER
FUNCTION RECORDS (8)
Notes:
(1) * Designates DEFAULT selections.
(2) See facing page for more information and examples.
(3) To delete preambles Scan I then either another selection (roman numeral) or Exit.
scan
(4) To delete postambles Scan II then either another selection (roman numeral) or Exit.
(5) Default is NO if Beep PC is enabled.
(6) This programming feature has been changed for Mask C. Refer to the cable
labeling to determine which firmware you have.
(7) This programming feature is not supported in all models/software revisions.
(8) Available for Mask C only .
EXIT
OUTPUT PARAMETERS
& FORMAT SELECTION
scan variables scan
Code ID A
Other ASCII B
ASCII values A
Enable
Primary
Secondary
Tertiary
Quaternary
x5msecs
x5msecs
x5msecs
Beep on Reset A
Beep on Good Read (7) B
scan
00–7F
None*
00–7F
None*
*Yes/No
01*
02
03
04
*00–99
*00–99
*00–99
*Yes/No
*Yes/No
*Yes/No
*Yes/No
9