Welch Allyn SCANTEAM 3210 Series Operating Manual And Programming Menu page 127

Does the 3210 read your bar code incorrectly?
If the 3210 reads a bar code ( one beep for a good read ), but
the bar code is not displayed correctly on the host screen:
The 3210 may not be programmed for the appropriate
terminal interface.
Example: You scan "12345" and the host displays "@es%."
Reprogram the 3210 with the correct "Plug and Play"
or Terminal Selection bar code ( see Section 2.2, 2.3 ).
The 3210 may not be programmed to output your bar
code properly.
Example: You scan "12345" and the host displays
"A12345B."
Reprogram the 3210 with the proper Symbology
selections ( see Sections 3.4 and 3.5 ).
The 3210 won't read your bar code at all?
If the 3210 will not read your bar code:
Try scanning the Sample Bar Codes ( found inside the
back cover ).
If the 3210 reads the Sample Bar Codes, check that your
bar code is readable. ( See "Is the 3210 having trouble
reading your bar codes" on the previous page. )
Verify that your bar code symbology is enabled. ( See
Sections 3.4 and 3.5. )
If the 3210 does not read the Sample Bar Codes either,
continue to #2, below...
If the 3210 won't read the Sample Bar Codes either:
Verify that the bar code symbologies are enabled. ( See
Sections 3.4 and 3.5. )
Scan ENTER, DEFAULT, and EXIT on the first pages of
Sections 3.4 and 3.5 to enable most symbologies. (
and Plessey will have to be enabled individually in Section 3.5.
Maintenance and Troubleshooting
6–4
MSI
)