Welch Allyn SCANTEAM 3210 Series Operating Manual And Programming Menu page 31

Programming Instructions
Resetting Default Settings
The first page of each programming section allows you to
program the SCANTEAM 3210 to factory settings for that
particular section. This is useful if you've changed the
features (or don't know what's been programmed) and
want to reset the 3210 defaults, but not all its defaults.
To reset the 3210 to factory settings for a particular
programming section, turn to that section and:
Scan the "ENTER" bar code to enter programming
mode.
Scan the "DEFAULT" bar code to set factory settings.
Factory settings are indicated by " " (asterisks).
Scan the "EXIT" bar code to exit programming mode.
Changing Settings
To change the default values, turn to the programming
selection you want to change:
Scan the "ENTER" bar code to enter programming
mode (unless noted otherwise).
Scan the Selection bar code ( the bar codes toward
outside edge of page ).
Scan the option bar code ( centered on page ) to make
your programming choice, then scan "EXIT."
Programming sequence is numbered (
code, bar code title, or text describing bar code.
3–2 Additional Programming
, , , etc.) next to bar