Calibration Submenus - Ultramat 6 - Siemens Set CEM CERT Operating Instructions Manual

8.4.3 Calibration submenus – ULTRAMAT 6
After you touch the <Calibration U6> button in the main menu, the submenu below with
the parameters described in the following table appears.
Control panel
Calibrate
CO
Start AUTOCAL
Set CEM CERT
Operating Instructions, 03/2020, A5E34491309-11
component
, e.g. Calibrate
Meaning
Single calibration of one component, e.g. CO
Start of AUTOCAL
Display of the current day of the week (1 = Sunday;
7 = Saturday);
in the example on the left, 4 = Wednesday
Display of the current time
Setting of the weekday on which an AUTOCAL is to take
place every week
Setting of the start time of a weekly AUTOCAL
Operation
8.4 Submenus
45