User-Defined Calibration / Scaling Of The Current Output - Siemens MPA 1 Series Instruction Manual

s
 Select the correct COM port
 Set the correct parameters for the serial interface (see chapter
transmission of measurement values)
 Open the connection
14. User-defined calibration / scaling of the current out-
put
If necessary, the pyrometer can be adjusted with a user-defined calibra-
tion function. The following drawing explains the effects for offset and
factor.
T
shall
Caution:
To recalibrate your ARDOMETER MPA, you will require a calibration
furnace and a reference standard.
In addition to a user-defined calibration, the user-defined range function
can also be activated. With this function being active, scaling of the cur-
rent output can be extended.

Please note:
The measuring accuracy is not defined when the scal-
ing is outside the pyrometer range.
Operating Manual MPA
Current state
Influence - factor
Influence - offset
T
Pyrometer
43