Siemens Set CEM CERT Operating Instructions Manual page 48

Operation
8.4 Submenus
After you touch the <Calibrate
parameters described in the following table appears.
Control panel
Zero gas
Calibration gas
Calibrate
ENTER
Start MEAS
46
component
> button, the submenu below with the
Meaning
Selection of the zero point calibration
Selection of the full-scale value calibration
Start of a single calibration
Acceptance of the newly calibrated value
End of the calibration, return to measuring mode
Input of a reference value for the calibration
Operating Instructions, 03/2020, A5E34491309-11
Set CEM CERT