Commissioning; Preparations; Visual Inspections - Siemens Set CEM CERT Operating Instructions Manual

Continuous gas analysis

Hide thumbs Also See for Set CEM CERT:

Table of Contents

Commissioning

7.1

Harmful gases

Danger to personnel, system and the environment can result from introducing harmful

(corrosive, flammable and/or poisonous) gases into the device. If this should be

required for the measuring task of the device, you must take the following measures:

• Take into account the safety measures according to the German Occupational

• Ensure that the discharged gas is treated according to the applicable local laws.

• Flammable gases must not be introduced into the system.

• Purge the device or the plant with a purging gas (inert gas). The gas displaced by

7.1.1

The system is safely installed mechanically; there is no risk of injury. All electrical

connections are touch-safe and are marked. A check is also made to determine if

additional warnings need to be incorporated in the documentation.

All surfaces that could become hot are isolated or covered to prevent accidental touch.

NOTICE

Danger of burns

Hot contact surfaces > 55°C are marked with a warning notice. Burns may result if

these surfaces are touched with bare skin.

• Only touch these surfaces when wearing protective gloves.

Set CEM CERT

Operating Instructions, 03/2020, A5E34491309-11

WARNING

Safety Act (Arbeitsschutzgesetz - ArbSchG) or similar international regulations.

These safety measures must be coordinated with a local specialist. In particular, this

includes measures to prevent any potential release of gases from the internal gas

path (containment system) as well as their monitoring and disposal.

purging must be collected using appropriate equipment and disposed of

environmentally-friendly via an exhaust line.

Table of Contents