Equidistant Master Cyclic Component Tdx - Siemens SIMOTION ADI4 Manual

Parameter assignment
3.6 Parameter assignment of the DP communication
Dialog: Start
Dialog: DP slave properties
Figure 3-8
3.6.3

Equidistant master cyclic component TDX

Procedure
Once synchronization to the equidistant DP cycle has been enabled for all DP slaves, the
time required for the cyclic component of the DP communication must be recalculated.
The calculation is performed automatically by the DP master each time the equidistant bus
cycle is enabled. This is performed in the following dialog box by selecting/clearing the
"Activate equidistant bus cycle" check box.
56
Tab: Isochronous operation
Radio button: Synchronize drive to equidistant DP cycle ☑
Button: Alignment
"DP Slave Properties" dialog box
SIMOTION ADI4 - Analog Drive Interface for 4 Axes
Manual, 05/2009, 6FC5 297-0BA01-0BP6