After The Exposure; Remove The Hygienic Protective Sleeve From The Sensor; With Single-Use Sensor Holder System - Dentsply Sirona Xios AE Operating Instructions Manual

Dentsply Sirona
Operating Instructions Xios AE Sensor USB interface and sensors
67 29 433 D3780
D3780.201.01.01.02 09.2019
5

After the exposure

Remove the hygienic protective sleeve from the
5.1
sensor
5.1.1

With single-use sensor holder system

Have the sensor holder tab and the sensor holder glued onto the
hygienic protective sleeve. This makes it easier to remove the hygienic
protective sleeve.
NOTE
The sensor cable is sensitive to mechanical influences.
The cable may become damaged or may wear out prematurely.
➢ Do not pull on the sensor cable when pulling the sensor out of the
hygienic protective sleeve. Slide the sensor further out of the
hygienic protective sleeve with your thumb as described below.
➢ Avoid bending, creasing or rotating the cable or exposing it to
other strains.
1. Grasp the guide rod in one hand so that you can touch the side of
the sensor facing away from the sensor cable with your thumb.
2. Carefully push the sensor out of the part of the hygienic protective
sleeve that is glued to the sensor holder tab with your thumb.

5.1 Remove the hygienic protective sleeve from the sensor

5 After the exposure
61