Table of Contents
Advertisement
Dentsply Sirona
Operating Instructions Xios AE Sensor USB interface and sensors
67 29 433 D3780
D3780.201.01.01.02 09.2019
5.1.2
With Aimright reusable sensor holder system
NOTE
The sensor cable is sensitive to mechanical influences.
The cable may become damaged or may wear out prematurely.
➢ Do not pull on the sensor cable when pulling the sensor out of the
hygienic protective sleeve. Slide the sensor further out of the
hygienic protective sleeve with your thumb as described below.
➢ Avoid bending, creasing or rotating the cable or exposing it to
other strains.
1. Remove the sensor with the hygienic protective sleeve from the
sensor holder. To do this, open up the sensor holder by pressing
gently on one side as shown in the figure.
2. Carefully push the sensor out of the narrow part of the hygienic
protective sleeve with two fingers.
3. Slide the sensor further out of the hygienic protective sleeve.
4. Hold on to the sensor and remove it from the hygienic protective
sleeve.
5.1 Remove the hygienic protective sleeve from the sensor
5 After the exposure
63
Advertisement
Table of Contents
