Appendix A: Initial System Setup; Tools; Fasteners & Parts - CellScale BioTester User Manual

10. Appendix A: Initial System Setup

The BioTester has been packed in a special container to protect it during shipping. In addition,
system accessories have been packed in several cartons contained in a separate box. The
system components listed below may be unpacked and laid out before system setup. A space
60cm x 60cm with 100cm overhead clearance is required for setup.

Tools

Small flat head screwdriver
SAE hex wrenches: 1/16", 3/32", 7/64", 9/64", 5/32",5/16"
Metric hex wrenches: 2mm, 2.5mm
SAE Combination Wrench 5/16"
Fasteners & Parts
1 BioTester main unit
6-32 X 1/2" Socket Head Cap Screws
16
6 6-32 Hex Nuts (4 + 2 extra)
12 5mm Magnets
12 7.5mm Magnets
20 BioRakes (5 sets of 4 each)
2 Load Cells
1 Calibration Spring
2 Calibration Spring Brackets
1 Camera Lens (10X Zoom)
2 5mm Camera Lens Spacer Tubes
1 Specimen Mounting Bridge
2 Load Cell Goosenecks
2 No-Load Cell Goosenecks
2 Load Cell Brackets
1 Standard Specimen Cutting Jig
4 Razor Blades for Cutting Jig
(2 + 2 extra)
1 Fluid Bath
1 Power Cord and Supply
6' (1.8m) USB Cable
1
1 Set of Shims (Thin and Thick)
1 Press Block
1 Sheet of Rubber Backing Material
4 Actuator Caps
1 3"x1" Microscope Slide
1 Pull knob
1 Temperature sensor
1 Set extra fasteners
BioTester User Manual
45