Table of Contents
Advertisement
Message
Close
stacker cover
Duplex disabled
Press GO
Duplex drawer
not loaded
Face-down tray
paper full
Face-up tray
path error
File not found
Press GO
Finisher tray ##
paper full
Finisher
path error
Format error
Memory Card
Format error
Hard disk
Hard disk err ##
Press GO
I/F occupied
ID error
Incorrect slot
Please reinstall
Table 4-3 (Continued)
Corrective Action
The optional bulk stacker (ST-30) cover is open. Close the cover.
You attempted to print with a paper size and paper type that cannot be used
for duplex printing. Press the GO key to print onto one-side of the paper
only.
The duplex drawer is not installed. Install the duplex drawer. This message
is applicable to the DN model.
The face-down tray has become full (approx. 500 pages). You must remove
all printed pages from the face-down tray. When the printer detects that the
face-down tray is empty again, the printer will continues printing into the
face-down tray.
The face-up tray is not open although you have attempted to print in the
face-up tray. Open the face-up tray.
You have attempted to print a job that is not contained in the specified virtual
mailbox, or the specified virtual mailbox is not found.
If Auto Continue is set to On, printing will be automatically resumed after a
preset period of time. For details on Auto Continue, refer to
the Operator
Panel.
The optional document finisher (DF-31) tray is full. Remove all printed
pages from the tray.
The optional document finisher (DF-31) is not installed properly. Correct
the installation, by referring to the instructions supplied with the document
finisher.
The memory card inserted in the printer is not formatted, and therefore can-
not be read or written. To format a memory card, follow the procedure in
Chapter 3 Using the Operator Panel, section Formatting a Memory Card
on page
3-64.
The hard disk installed in the printer is not formatted, and therefore cannot
be read or written. To format the hard disk, follow the procedure in the
Installation Guide of the hard disk.
A hard disk error has occurred. Look at the error code given in place of ##
and refer to
Storage Error Codes on page
press the GO key.
This message is displayed when you attempt to use the printer's operator
panel to change the environmental settings on the interface from which data
are presently being received.
The user ID entered for a private job, or a stored job is not correct. Check the
user ID that you specified on the printer driver.
The optional hard disk is installed in the network interface card slot (OPT)
in the printer.
The optional network interface card is installed in the hard disk slot (HDD)
in the printer.
Install it in the appropriate slot.
4-7
4.3 Error Messages
Chapter 3 Using
4-11. To ignore the hard disk error,
Advertisement
Table of Contents
