Resolving Ip Address - Xerox FS-C8008DN Operation Manual

3.5.4

Resolving IP Address

To connect the printer to the network using TCP/IP protocol, you must set the IP address on
the printer. The IP address must be unique to the printer and should be obtained from your
network administrator.
1 1 1 1
Activate TCP/IP protocol in the manner described above.
>TCP/IP
On
2 2 2 2
Enter the submenu by pressing the
selection changes as shown below.
>>DHCP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
3 3 3 3
When >>IP Address is displayed, press the ENTER key. A blinking cursor (_)
appears at the last digit.
>>IP Address
000.000.000.000
4 4 4 4
Press the or
cursor. Use the
5 5 5 5
When the IP address is entered, press the ENTER key.
6 6 6 6
Press the or
complete entering the subnet mask address.
7 7 7 7
Then, press the
complete entering the subnet mask address.
8 8 8 8
Press the MENU key. The display returns to Ready. You can print a network status
page to confirm that the IP address, subnet mask address, and the gateway address
have been properly set. To print a network status page, see
Interface Status Page
>
key. Each time you press the
key to increase or decrease, respectively, the value at the blinking
and keys to move the cursor right and left.
key to move to Subnet Mask. Perform the same procedure to
or key to move to Gateway. Perform the same procedure to
which follows.
3-39
3.5 Changing the Interface Parameters
or
Printing a Network
key, the