Table of Contents
Advertisement
3.6 Making Default Settings
3.6.5
Default Font
You can select the default font for the current interface. The default font can be one of the
internal fonts or a font that is downloaded to the printer memory or stored on memory card
or hard disk.
In this menu, you can also set the type and pitch for Courier and Letter Gothic; as well as to
print a font list.
1 1 1 1
Press the MENU key.
2 2 2 2
Press the
or
Font
3 3 3 3
Press the
key. Press the
>Font Select
Internal
4 4 4 4
To select an internal font, make sure that Internal is displayed and press the
key. The display changes as shown below. If Internal is not displayed, press the
ENTER key, then press the
>> I000
To select an optional font, press the ENTER key while >Font Select > is
displayed. Press the
the ENTER key. Press the
You can perform this operation only when optional fonts are installed in the printer.
The letter before the number indicates the location of the font, as shown below:
Internal font
I
S
Soft (downloaded) font
M
Fonts in optional memory card
H
Fonts in RAM disk or optional hard disk
Fonts in optional ROM (API)
O
5 5 5 5
Press the ENTER key. A blinking question mark (?) appears.
>>?I000
6 6 6 6
Press the
or
numbers of the internal fonts, see
7 7 7 7
When the desired font is displayed, press the ENTER key.
8 8 8 8
Press the MENU key. The display returns to Ready.
key repeatedly until Font > appears.
>
or
key until >Font Select > appears.
>
or
key until it appears.
or
key repeatedly until Option appears and then press
key next to display the font selection shown above.
key repeatedly until the desired font number appears. For font
Printing Lists of Fonts on page
3-46
3-51.
Advertisement
Table of Contents
