Table of Contents
Advertisement
3.5.3
Changing Network Interface Parameters
This printer supports TCP/IP, NetWare and EtherTalk protocols. In addition, you can install
the optional network interface card in the printer's extension slot (OPT).
Using the operator panel, you can:
•
Activate or deactivate TCP/IP, NetWare, and AppleTalk
•
Activate or deactivate DHCP
•
Enter IP address, subnet mask address, and default gateway address
•
Determine whether to print a network status page when the printer is turned on
To confirm or change network card parameters, proceed as follows:
1 1 1 1
Press the MENU key.
2 2 2 2
Press the
or
3 3 3 3
If the current interface is other than network, press the ENTER key. A blinking
question mark (?) appears.
Interface
? Parallel
If the optional network interface card is installed in the printer, Option will be
displayed. The setting procedure is basically the same even in this case.
4 4 4 4
Press the
or
Interface
? Network
5 5 5 5
Press the ENTER key again.
key repeatedly until Interface > appears.
>
key repeatedly until Network appears.
>
3-37
3.5 Changing the Interface Parameters
Advertisement
Table of Contents
