Table of Contents
Advertisement
3.13 Other Modes
3.13.8 Auto Continue Setting
Note
If an error that still allows you to continue printing occurs (Memory overflow Press
GO, Print overrun Press GO, KPDL error Press GO, File not found
Press GO, RAM disk error Press GO, MemoryCard err Press GO, Hard
disk err Press GO, and Duplex disabled Press GO), the next received data
is automatically printed after a set period of time elapses. For example, if the printer is
shared over a network as a network printer and one person causes one of the above errors,
after the set period of time elapses, the data sent from the next person is printed. The default
setting is Off (Auto Continue disabled).
For setting the auto continue recovery time, see the next section.
1 1 1 1
Press the MENU key.
2 2 2 2
Press the
or
Others
3 3 3 3
Press the
key
4 4 4 4
Press the
or
>Auto Continue >
Mode
Off
5 5 5 5
Press the ENTER key. A blinking question mark (?) appears.
>Auto Continue
Mode ? Off
6 6 6 6
Select On or Off using the
7 7 7 7
Press the ENTER key.
8 8 8 8
To exit the menu selection, press the MENU key. The display returns to Ready.
key repeatedly until Others > appears.
>
key repeatedly until Auto Continue > appears.
or
key.
3-96
Advertisement
Table of Contents
