Changing Serial Interface Parameters - Xerox FS-C8008DN Operation Manual

3.5.2

Changing Serial Interface Parameters

Note
8 8 8 8
Press the or
Nibble (high)
Auto
Normal
High Speed
9 9 9 9
When the desired communication mode is displayed, press the ENTER key.
10 10 10 10
Press the MENU key to exit the menu selection.
This section applies to the printers having the option serial interface board kit (IB-11)
installed.
You can confirm or change the serial interface parameters including baud rate, data bits,
stop bits, parity, and protocol. These parameters must match those of the computer's serial
interface.
1 1 1 1
Press the MENU key.
2 2 2 2
Press the or
3 3 3 3
If the interface is other than serial, press the ENTER key. A blinking question mark
(?) appears.
Interface
? Parallel
4 4 4 4
Press the or
Interface
? Serial
5 5 5 5
Press the ENTER key again.
6 6 6 6
Press the key. One of the following serial parameters is indicated (Baud rate
for example).
key to scroll through the following communication modes:
key repeatedly until Interface > appears.
key repeatedly until Serial appears.
3-35
3.5 Changing the Interface Parameters