Type Labels And Setting Marks - Honeywell GasLab Q2 Manual

3.4.

Type labels and setting marks

The main type label with the most important information is located below the interactive screen,
behind the inspection window. If the type label is covered by the sand guard, this information can
also be read off an additional type label on the outside of the housing. In some cases, the main type
label does not offer enough space for all information, so there may be additional warning and type
labeles on the housing. The following figure shows the positions of the type labels and warnings on
the device.
Figure 3.5: Example positions of the type labels and warnings
The equipment of the device with type lables depends on the country of use and the approvals. The
type labels will vary in terms of language and the specified standards or regulations. However, the
following information is always contained on the label(s):
Information
Manufacturer and manufacturer's address with the address of the production site
Device type, type designation, serial number and year of manufacture MM/YYYY
Warning to refer to this document, environmental regulations to be complied with and
2 D matrix code
Gas inlet pressure range* Ambient temperature range Enclosure (protection class (IP))
Voltage and power consumption
Warning and connection instructions, on a separate label if several languages are necessary
* The input pressure range depends on the application; deviations are also possible on request.
Information on the device (type labeles and engravings) must always be observed and
followed!
Les informations sur l'appareil (étiquettes et gravures) doivent toujours être respectées et
suivies!
Information for general use
Rev. M / 73023639
STRUCTURE AND INSCRIPTIONS OF THE GASLAB Q2
48 GasLab Q2