Mitsubishi Electric CR800-05VD Standard Specifications Manual page 66

3 Controller
Parameter
name
Name
AIRERR1 Pneumatic
pressure error 1
input signal
: :
AIRERR3 Pneumatic
pressure error 3
input signal
M1PTEXC
:
M3PTEXC
USERAREA
Note3)
Note1) The level indicates the signal level.
L: Level signal → The designated function is validated when the signal is ON, and is invalidated
E: Edge signal → The designated function is validated when the signal changes from the OFF to
Note2) Four elements are set in the order of input signal start No., end No., output signal start No. and end
No.
Note3) Up to eight points can be set successively in order of start output signal No. and end output signal No.
3-58 Dedicated input/output
Input
Function
Request the pneumatic pressure
error occurrence.
None
None
when the signal is OFF.
ON state, and the function maintains the original state even when the signal then
turns OFF.
Note1)
Level Name
Pneumatic pressure
error 1 output
signal.
L :
Pneumatic pressure
error 3 output
signal.
Maintenance parts
replacement time
L
warning signal
User-designated
area 32-points
Output
Function
Outputs that a pneumatic pressure
error is occurring.
Outputs that the maintenance parts
have reached the replacement time.
Outputs that the robot is in the user-
designated area.