Adjustments; Uni-Directional Adjustment - Xerox 8290 User Manual

7.1 UNI-DIRECTIONAL ADJUSTMENT

The Uni-directional (Uni-D) Adjustment is used to align print head 2, 3 and 4 (Adjustment Head) to print
head 1 (Reference Head) for uni-directional printing (right-to-left only). It should be performed whenever
the printing environment or the media type is changed.
Power ON the printer and setup the media at the control panel.
Step 1 :
Print the Uni-D Test Print. At the control panel, navigate to Setup Menu 1/7 and select F3
Step 2 :
TestPrint > F3 Adj. Uni-D.
There may be a slight delay between the time that the Uni-D Test Print is selected and the
time that it actually prints.
Analyze the Uni-D Test Print. Beginning with Print Head 2, observe the lines for the
Step 3 :
Adjustment Head in relation to the Reference Head lines. Select the number (1 – 7), on left
side of the test print, where the Reference Head and the Adjustment Head are best aligned.
For example, in the figure below, number "4" is where the Reference Head and the
Adjustment Head are aligned the best for Print Head 2.
8265/8290/8365/8390 User Guide

7 ADJUSTMENTS

133