Table of Contents
Advertisement
5 Troubleshooting
(14) Media is crooked while printing.
No.
Possible cause
1
You did not use recommended
media.
2
The loading position of the media
is not correct.
(15) The printer is not connected to a computer using the Centronics interface.
No.
Possible cause
1
When the printing data is
transferred from the computer,
the DATA lamp on the operation
panel is not lit.
2
The type of command that is
currently set, does not match the
command of a computer or a
driver.
(16) The printed lines are blurred.
No.
Possible cause
1
You did not use recommended
media.
2
You used too thick or too thin
media.
3
You used bond media.
4
The printed surface is not the
printable side.
5
Did you try head cleaning?
96
Solutions
Use recommended
media.
Load the media correctly.
Solutions
If the DATA lamp is not
lit, contact the computer
maker.
Match the command
setting of the printer to
the environment of a
computer or a driver.
Solutions
Use recommended
media.
Use recommended media
Use recommended
media.
Pay attention to the
printable side to load
media correctly.
Perform head cleaning.
Perform strong cleaning.
Clean the surface of the
print head.
Perform long save
cleaning.
References
Refer to 'Media type'
Refer to 'Loading media'
References
-
Refer to 'Menu Overview'
References
Refer to 'Media type'
Refer to 'Media type'
Refer to 'Media type'
Refer to 'Media handling'
Refer to 'Head cleaning'
Refer to 'Cleaning the cleaning
wiper'
8265/8290/8365/8390 User Guide
Advertisement
Table of Contents
