Table of Contents
Advertisement
3.1 TURNING THE PRINTER POWER ON/OFF
The method to turn the power ON or OFF is described below.
Caution
Before powering ON the unit, make sure the waste bottle is installed.
3.1.1 Turning the Power ON
Turn the power of the unit ON according to following procedure.
Press the [POWER] key of the operation panel, to turn the unit ON.
Step 1 :
The POWER lamp of the operation panel will light (green).
The unit will start initial start-up operations.
Step 2 :
After finishing initial start-up operations, the unit will enter the normal operating condition.
Step 3 :
Notes
If there are any problems during the initial start-up operation, the unit will display a message on the
operation panel, and the operation may stop. If the operation stops, refer to "Troubleshooting", and take
the appropriate actions.
3.1.2 Turning the Power OFF
Turn the power of the unit OFF according to the following procedure.
Verify the following regarding the operational condition of the unit.
Step 1 :
There is no printing operation being performed.
The operation panel is in a normal status.
Press the [POWER] key of the operation panel to turn the unit OFF.
Step 2 :
8265/8290/8365/8390 User Guide
3 PRINTER SETUP
19
Advertisement
Table of Contents
