5.4 WHEN MEDIA JAMS OCCUR
If the loaded media gets jammed in the printer, follow the steps below to remove the media.
Press [F4] to raise the pressure rollers.
Step 1 :
Notes
For raising or lowering the pressure rollers, you can use the foot switch instead of the operation panel.
If a piece of media or media dust is stocked in the printer, open the front cover and remove
Step 2 :
the piece of media or media dust.
Caution
Be sure not to pinch your fingers while opening and closing media cover.
If there is an error requiring a restart, power the printer OFF and ON again.
Step 3 :
Go to Media Handling in the User Guide to re-load the media.
Step 4 :
8265/8290/8365/8390 User Guide
Front Cover
1
5 Troubleshooting
103