Table of Contents
Advertisement
Guide to Printing Using Xerox Production Print Services
6. Select [Print]. The job is sent to the printer for reprinting.
Reprinting with different job ticket parameters
When a job is saved, its job ticket is saved with it. The job may
be reprinted with different job ticket parameters as necessary.
The saved job ticket cannot be changed. The job may be
submitted for reprinting with new parameters, but the new
parameters do not affect the saved ticket.
All of the job ticket parameters may be changed except the PDL
Type, which is set to [Printer default].
1. In the [Document] field on the XDS window, enter or browse
to locate and display the path to the document that will be
reprinted. If the save directory is the default save location that
was set at the DocuSP controller, then entering a source
directory path is not necessary. If a source directory that is
different from the default save directory was selected, enter
the directory path to the save location.
NOTE: The source directory and file names are case
sensitive and must be identical to the name of the file that
was submitted to be saved. Note that some network gateway
software changes the case to all lowercase or all uppercase.
2. Select the [Reprint] check box. A message appears,
informing you that the job ticket settings that were saved with
the job will be used.
3. In the message window, select [OK] to proceed with
reprinting.
4. Select [Setup].
5. Enter the job ticket parameters that you want to change from
the saved ticket parameters. For parameters that you wish to
keep the same as they were set in the saved job ticket, either
leave the parameters blank or set them to [Printer Default].
NOTE: When [Reprint] is selected in the Xerox Document
Submission window, all of the job ticket parameters are set to
either the system defaults or to [Printer Default].
6. Select [OK].
7. Select [Print]. The job is sent to the printer for reprinting.
Job ticket options
9-35
Advertisement
Table of Contents
