Caenvme_Setbusreqlevel; Caenvme_Settimeout; Caenvme_Setfifomode - Caen V2718 Technical Information Manual

Document type: Title:
User's Manual (MUT) Mod. V2718 VME PCI Optical Link Bridge
4.3.31.
Parameters:
Returns:
Description:
CAENVME_API
CAENVME_SetBusReqLevel(long Handle, CVBusReqLevels Value).
4.3.32.
Parameters:
Returns:
Description:
CAENVME_API
CAENVME_SetTimeout(long Handle, CVVMETimeouts Value).
4.3.33.
Parameters:
Returns:
Description:
CAENVME_API
CAENVME_SetFIFOMode(long Handle, short Value).
NPO:
00106/03:V2718.MUTx/11

CAENVME_SetBusReqLevel

[in] Handle : The handle that identifies the device.
[in] Value : The type of VME bus requester priority level to set
(see CVBusReqLevels enum).
An error code about the execution of the function.
The function sets the specified VME bus requester priority level on the
module.

CAENVME_SetTimeout

[in] Handle: The handle that identifies the device.
[in] Value: Value of VME bus timeout to set (see CVVMETimeouts enum).
An error code about the execution of the function.
The function sets the specified VME bus timeout on the module.

CAENVME_SetFIFOMode

[in] Handle : The handle that identifies the device.
[in] Value : Enable/disable the FIFO mode.
An error code about the execution of the function.
The function enables/disables the auto increment of the VME addresses
during the block transfer cycles. With the FIFO mode enabled the
addresses are not incremented.
Filename:
V2718_REV11.DOC
Revision date: Revision:
03/07/2018 11
Number of pages:
79
Page:
70