Software User Interface: I/O Setting Menu - Scaler; Software User Interface: I/O Setting Menu - Location Monitor; Fig . 49: The I/O Setting Menu; Fig . 50: The I/O Setting Menu - Caen V2718 Technical Information Manual

Document type: Title:
User's Manual (MUT) Mod. V2718 VME PCI Optical Link Bridge
4.1.6. Software User Interface: I/O Setting Menu – Scaler
The Scaler Setting Menu allows to perform the settings of the V2718 built in scaler (see
§ 3.7). The V2718 features an internal scaler, which counts hits arriving on the enabled
front panel input (Input_0 or Input_1). Gate and Reset signals can be sent either on the
unused input connector or software generated; an End_Count_Pulse is eventually
available on Out_4. The End_Count field allows to set the number of hits to be stored
(End_Count_Limit); Auto Reset and Loop options can be either enabled or disabled
independently. The lowest field allows to read the stored hits. Refer also to § 2.13.21.
4.1.7. Software User Interface: I/O Setting Menu – Location Monitor
The Location Monitor Setting Menu allows to produce an output signal when a particular
VME cycle, at a particular base address, is detected; see § 2.7 for details.
NPO:
00106/03:V2718.MUTx/11
Fig. 49: The I/O Setting Menu – Scaler
Fig. 50: The I/O Setting Menu – Location Monitor
Filename:
V2718_REV11.DOC
Revision date: Revision:
03/07/2018 11
Number of pages:
79
Page:
54