Fig . 42: Caenu Pgrader ' S "U; Fig . 43: Vme Index In The Fig . 44: Firmware Revision On The - Caen V2718 Technical Information Manual

Document type: Title:
User's Manual (MUT) Mod. V2718 VME PCI Optical Link Bridge
To upgrade the firmware of the boards, the user must select in the "Bridge Upgrade" tab
the "Upgrade Firmware" option, set the "Bridge Model", configure the connection
parameters and point to the firmware file to be uploaded. The tab allows also to select
which FLASH page to be written.
The VME "Board number" parameter refers to the position of the V2718 in the CONET
network and ranges from 0 to 7, as shown the following picture:
the PCI/PCIe "Link number" parameters indicates which link of A2818 or A3818 is used;
the index starts from 0 (1
which is the first slot used (it depends on the motherboard of the PC used.).
IMPORTANT NOTE: if A2818 and A3818 are installed together, the A2818 have lower
index assigned.
It is suggested to upgrade the three devices in the following order: A2818 (or A3818),
A2719, V2718.
NPO:
00106/03:V2718.MUTx/11
Fig. 42: CAENUpgrader's "Upgrade Firmware" view
PC side
TX
A2818
RX
Fig. 43: VME Index in the CONET network
st
Optical link port in the 1
Filename:
V2718_REV11.DOC
Revision date: Revision:
03/07/2018 11
Crate side
RX
V2718 #0
TX
RX
V2718 #1
TX
RX
V2718 #7
TX
st
slot used). It is not known a priori
Number of pages:
79
Page:
47