Caenvme_Setoutputconf; Caenvme_Readregister; Caenvme_Setoutputregister - Caen V2718 Technical Information Manual

Document type: Title:
User's Manual (MUT) Mod. V2718 VME PCI Optical Link Bridge
4.3.22.
Parameters:
Returns:
Description:
CAENVME_API
CAENVME_GetOutputConf(long Handle, CVOutputSelect OutSel, CVIOPolarity *OutPol,
CVLEDPolarity *LEDPol, CVIOSources *Source).
4.3.23.
Parameters:
Returns:
Description:
CAENVME_API
CAENVME_ReadRegister(long Handle, CVRegisters Reg, unsigned short *Data).
4.3.24.
Parameters:
Returns:
Description:
CAENVME_API
CAENVME_SetOutputRegister(long Handle, unsigned short Mask).
NPO:
00106/03:V2718.MUTx/11

CAENVME_SetOutputConf

[in] Handle : The handle that identifies the device.
[in] OutSel : The ouput line to configure (see CVOutputSelect enum).
[out] OutPol : The output line polarity (see CVIOPolarity enum).
[out] LEDPol : The output LED polarity (see CVLEDPolarity enum).
[out] Source : The source signal to propagate to the output line (see
CVIOSources enum).
An error code about the execution of the function.
The function permits to read the configuration of the output lines.

CAENVME_ReadRegister

[in] Handle: The handle that identifies the device.
[in] Reg: The internal register to read (see CVRegisters enum).
[out] Data: The data read from the module.
An error code about the execution of the function.
The function permits to read some internal registers: the input register,
the output register and the status register. For the meaning and decoding
of register bits see CVStatusRegisterBits, CVInputRegisterBits and
CVOutputRegisterBits definitions and comments.

CAENVME_SetOutputRegister

[in] Handle : The handle that identifies the device.
[in] Mask : The lines to be set.
An error code about the execution of the function.
The function sets the specified lines. Refer the CVOutputRegisterBits
enum to compose and decode the bit mask.
Filename:
V2718_REV11.DOC
Revision date: Revision:
03/07/2018 11
Number of pages:
79
Page:
67