Caenvme_Getpulserconf; Caenvme_Getscalerconf - Caen V2718 Technical Information Manual

Document type: Title:
User's Manual (MUT) Mod. V2718 VME PCI Optical Link Bridge
4.3.20.
Parameters:
Returns:
Description:
CAENVME_API
CAENVME_GetPulserConf(long Handle, CVPulserSelect PulSel, unsigned char *Period,
unsigned char *Width, CVTimeUnits *Unit, unsigned char *PulseNo, CVIOSources *Start,
CVIOSources *Reset).
4.3.21.
Parameters:
Returns:
Description:
CAENVME_API
CAENVME_GetScalerConf(long Handle, short *Limit, short *AutoReset,
CVIOSources *Hit, CVIOSources *Gate, CVIOSources *Reset).
NPO:
00106/03:V2718.MUTx/11

CAENVME_GetPulserConf

[in] Handle : The handle that identifies the device.
[in] PulSel : The pulser to configure (see CVPulserSelect enum).
[out] Period : The period of the pulse in time units.
[out] Width : The width of the pulse in time units.
[out] Unit : The time unit for the pulser configuration (see
CVTimeUnits enum).
[out] PulseNo : The number of pulses to generate (0 = infite).
[out] Start : The source signal to start the pulse burst (see
CVIOSources enum).
[out] Reset : The source signal to stop the pulse burst (see
CVIOSources enum).
An error code about the execution of the function.
The function permits to read the configuration of the pulsers.

CAENVME_GetScalerConf

[in] Handle : The handle that identifies the device.
[out] Limit : The counter limit for the scaler.
[out] AutoReset : The auto reset configuration.
[out] Hit : The source signal for the signal to count (see
CVIOSources enum).
[out] Gate : The source signal for the gate (see CVIOSources enum).
[out] Reset : The source signal to stop the counter (see
CVIOSources enum).
An error code about the execution of the function.
The function permits to read the configuration of the scaler.
Filename:
V2718_REV11.DOC
Revision date: Revision:
03/07/2018 11
Number of pages:
79
Page:
66