Caenvme_Setpulserconf - Caen V2718 Technical Information Manual

Document type: Title:
User's Manual (MUT) Mod. V2718 VME PCI Optical Link Bridge
4.3.16.
Parameters:
Returns:
Description:
CAENVME_API
CAENVME_SetPulserConf(long Handle, CVPulserSelect PulSel, unsigned char Period,
unsigned char Width, CVTimeUnits Unit, unsigned char PulseNo, CVIOSources Start,
CVIOSources Reset);
NPO:
00106/03:V2718.MUTx/11

CAENVME_SetPulserConf

[in] Handle : The handle that identifies the device.
[in] PulSel : The pulser to configure (see CVPulserSelect enum).
[in] Period : The period of the pulse in time units.
[in] Width : The width of the pulse in time units.
[in] Unit : The time unit for the pulser configuration (see
CVTimeUnits enum).
[in] PulseNo : The number of pulses to generate (0 = infinite).
[in] Start : The source signal to start the pulse burst (see
CVIOSources enum).
[in] Reset : The source signal to stop the pulse burst (see
CVIOSources enum).
An error code about the execution of the function.
The function permits to configure the pulsers. All the timing parameters
are expressed in the time units specified. The start signal source can be
one of: front panel button or software (cvManualSW), input signal 0
(cvInputSrc0),input signal 1 (cvInputSrc1) or input coincidence
(cvCoincidence). The reset signal source can be: front panel button or
software (cvManualSW) or, for pulser A the input signal 0 (cvInputSrc0),
for pulser B the input signal 1 (cvInputSrc1).
Filename:
V2718_REV11.DOC
Revision date: Revision:
03/07/2018 11
Number of pages:
79
Page:
63