Lubrication; Cutterbar; Intersecting Axis Gears - SaMASZ KDC 260 S Operator's Manual

4. Start the mower and in particular hydraulic drive, smoothly changing rpm.
5. Use bolts S to adjust by locking bolts S
2,
bulges on the belt.
NOTE:
Precision is recommended, so belts and their edges worked symmetrically on
rollers. Well-adjusted belt cannot be bulged in places where v-belt is guided
inside the roller channel.

7. LUBRICATION

7.1. Cutterbar

Cutterbar is filled with oil through plug closed hole A (Fig. 46). Adequate oil level with
horizontal position of the cutterbar is 5÷7 mm from the cutterbar's bottom. In order to drain oil from
the cutterbar dismount the cutterbar enclosure by releasing bolts (B). The best time to drain the oil
is immediately after the operation, if still warm. Amount of oil to be filled is provided in table 9.
A
Fig. 46. Points of oil inspection and replacement in cutterbar
Tab. 9. Amount of oil to be filled in cutterbar
Mower type
KDC – 2,60 m
KDC - 3,00 m
KDC – 3,40 m
KDC – 3,90 m
KDC – 4,30 m

7.2. Intersecting axis gears

Prior to operation (e.g. some more demanding a task) firstly examine oil level and if need be
refill it once air vent is taken out A in upper section of the gear (Fig. 47). Oil level is inspected by
opening check plug B on the side of the gear. If oil level is too low, refill oil until it is visible in the
check opening. Oil level in gear: approx. 1 litre. Plug C is used to drain oil.
Tab. 10. Amount of oil to be filled in gear
Mower type Oil volume [L]
All types approx. 1
NOTE:
The above provisions should be strictly kept. If discs found on the cutterbar
are able to move freely, then high temperature of axis gear should not be a
point of concern, as in result of a long-term operation it may reach 60-80°C.
Operator's manual
each time – perform these until there are no more
1
Oil volume [L]
5,0
6,0
6,5
7,0
2 x 4,5
Oil type
SAE 80W/90, API GL-4
- 40 -
Trailed disc mowers
KDC
B
Oil type Replacement frequency
After first 50 h of operation and
80W90 then after next 500 h (or at least
Replacement frequency
After first 50 h of operation and
then after next 500 h (or at least
once a year)
once a year)