Lubrication; Cutterbar; Intersecting Axis Gears - SaMASZ KDD 860 Operator's Manual

7. LUBRICATION

7.1. Cutterbar

Refilling oil in the cutterbar is done through the inlet A (Fig. 36). Proper oil level is 5÷7 mm
from the cutterbar bottom.
Tab. 4. Oil capacities
Model
KDD 860 S/W - 8,60 m
KDD 940 S/W – 9,40 m

7.2. Intersecting axis gears

Everyday before starting work please check the oil level and, if needed, please refill after
having removed the vent A on the top of the gear (Fig. 37). The oil level can be checked through
check opening B on the side of the gear. Please refill the oil until it is visible in the check opening
B. The oil capacity: about 1 l (Fig. 37a, b) and about. 2.5 l (Fig. 37c). Check oil level when
the cutterbar is on the ground. Removing the worked oil from the gearbox is done through
the outlet C.
a)
Operator's manual
Oil capacity [l]
2 x 7,0
2 x 8,0
A
Fig. 36. Cutterbar oil inlet A
A
B
b)
Fig. 37. Intersecting axis gears oil
Double-sided disc mowers
with central suspension
Oil type Lubrication frequency
80W90
(if working intyensively more frequently)
A
B
c)
- 34 -
Once every 3 seasons
A
B
C