Mounting Pto Shaft - SaMASZ KDC 260 S Operator's Manual

NOTE:
If the mower does not own the above warning lights and plates, these can be
ordered at the manufacturer.

5.4. Mounting PTO shaft

PTO shaft should be mounted with friction clutch from the mower side.
The guard should be protected against rotating by securing the shaft set chains to immovable
parts of the tractor and the mower.
NOTE:
If need be shorten PTO shaft as provided in corresponding operator's manual
(Fig. 14).
NOTE:
Use machines with correspondingly designed driving PTO shafts. Prior to the
work commencement, safety guards should be inspected whether they (in the
tractor, the mower and the PTO shaft) are placed correctly and are not
damaged. Damaged or missing parts must be replaced with genuine ones.
Make sure that the -PTO shaft is mounted properly. Approaching the rotating
parts is strictly forbidden, as it may lead to serious injuries or even cause
death. For any service and repair works of the shaft and the mower, the
tractor engine and its drive must be disconnected Prior to the operation
commencement, read the operator's manuals of both the machine and the
PTO shaft.
NOTE:
PTO shafts should be mounted with overriding friction clutch on the mower
side.
Operator's manual
Fig. 14. PTO shaft shortening instructions
- 23 -
Trailed disc mowers
KDC