Operating Parts; Pto Shaft; Hydraulic Assembly - SaMASZ KDC 260 S Operator's Manual

Tab. 7. Location of centre of gravity
Dimension
[mm]
A
B
Dimension
[mm]
KDC 300
4180
A
B 830
Dimension
[mm]
KDC 340
A
B
Dimension
[mm]
KDC 341
A
B

4.5. Operating parts

Prior to operating the mower check the knife, knife mountings and the knife holder condition.

Worn or damaged knives, knife mountings or knife holders should be replaced immediately

with new ones.
WARNING!
During replacement of working parts, it should be used personal protective
gloves.

4.6. PTO shaft

Before operating learn provisions found in bar manufacturer's manual placed on the bar.

Use only the mower's manufacturer recommended PTO shafts featuring guards in good

technical condition.
In order to operate safely use only fully technically fit, undamaged PTO shafts. Damaged PTO

shaft shall be repaired or replaced with new one.
Before any operation make sure whether PTO rpm have proper rotational direction.


4.7. Hydraulic assembly

Caution! Hydraulic assembly is under pressure! Hydraulic oil under pressure may permeate

through skin and cause serious injury, therefore skin and eyes should be protected in particular.
In case of injuries caused by a liquid under pressure, call a doctor immediately.
Hydraulic hoses can be connected to tractor's hydraulics, provided that both the tractor's and the

mower's hydraulic assemblies are not under pressure. To remove the pressure from the hoses
just simply restart the tractor's hydraulic valves several times, once the tractor is off.
When dismounting the machine from the tractor, set the equipment aside, deflate the pressure

from hydraulics and turn tractor's engine off.
When controlling for hydraulic assembly's malfunction and looking for oil leaks, it is forbidden

to touch any potential leaks until the entire assembly is under pressure.
Note! It is recommended that the hydraulic oil used should not exceed 10 oil purity class in

accordance with NAS 1638.
Operator's manual
KDC 260 S KDC 260 SL
4420
825
KDC 300 S KDC 300 SL KDC 300 ST KDC 300 SLT KDC 301 W KDC 301 WT
4440 4435
850 855
KDC 340 S
4610 4865
830 850
KDC 341 W
4610 4920
830 805
Trailed disc mowers
Mower type
KDC 260 ST
4415 4720
830 800
Mower type
4750
800
Mower type
KDC 340 SL KDC 340 ST
4860
855
Mower type
KDC 341 WT
5270
795
- 14 -
KDC
KDC 260 SLT
4720
805
4750 4460
800 820
KDC 340 SLT
5200 5200
795 795
KDC 390 KDC 430
4190 4700
815 805
4820
800