Swath Width Adjustment - SaMASZ KDC 260 S Operator's Manual

Fig. 25. Disc rotation directions on mower's cutterbar KDC 341 (wide swath)
Fig. 26. Disc rotation directions on mower's cutterbar KDC 390
Fig. 27. Disc rotation directions on mower's cutterbar KDC 430
NOTE:
Due to various windrow widths in offered mowers (and therefore various
rotation directions of discs), prior to mounting knives check rotation
directions of each disc (Fig. 22–Fig. 27).
NOTE:
Improper mounting of knives will lead the mower to choke. When mounting
pay particular attention to knife rotating freely on the holder's pin.
NOTE:
Due to high rpm of discs, knife holders should be replaced in pairs.
Otherwise, as a result of improper balancing, disc vibrations and damages to
bearings are likely.

6.4. Swath width adjustment

In order to set swath width, adjustment of swath guides (1) (Fig. 28) should be performed
(applies to: KDC S/SL):
loosen eye screw (2) of swath guide,

set swath guide (1) as needed,

tighten bolt (2).

Operator's manual
- 30 -
Trailed disc mowers
KDC