Replacement Of Flails In Conditioner Roller - SaMASZ KDC 260 S Operator's Manual

6.6. Replacement of flails in conditioner roller

(Applies to KDC S)
Prior to commencing any operation, on each occasion check condition of bolts, on which
flails are set, as well as condition of flails themselves. If flails or bolts are worn or damaged, it is
necessary to replace them. Bear in mind, that flails should be replaced in pairs (opposite)
featuring the same weight in order to keep shaft well balanced. Not keeping the shaft well
balanced may lead to premature wearing of bearings as well as the shaft itself.
To replace flails (2) unscrew nuts (4) by means of wrench, remove bolts (3) and mount brand
new flails (3) (Fig. 31).
1. Conditioner roller
2. Welded flail
3. Bolt M16x60 gal. cl. 10.9
4. Nut M16 self-protecting gal. cl. 8
5. Key 12x8x45
5
Fig. 32. Replacement of flails in light-weight conditioner roller
Operator's manual
Fig. 30. Conditioner plate adjustment
Fig. 31. Replacement of welded flails in conditioner roller
4
7
Trailed disc mowers
+
-
5
1
1. Conditioner roller
2. Plastic flail
3. Bolt M12x55 cl. 8.8
3 4. Nut M12 self-protecting gal. cl. 8
5. Key 12x8x45
6
6. Flail's insert
7. Plain washer ∅12
2
- 32 -
KDC
„+" - increasing clearance plate -
roller
„–" - reducing clearance plate -
roller
4
2
3
2
1