Tab. 8. Torque values for bolts
In the absence of specific torque values, the following chart can be used as a guide to the
maximum safe torque for a particular size and grade of fastener. There is no torque difference for
fine or coarse threads. Torque values are based on clean, dry threads. Reduce value by 10% if
threads are oiled before assembly.
6.11. Controlling condition of cog belt and tension
(Applies to KDC S / KDC W)
Drive from conditioner and rollers driving shaft is transmitted by cog belt onto conditioner's
axis. Constant belt tension is provided by tightener, adjusted with tensioning bolt B (Fig. 38).
O
S
Fig. 37a. Protective guard of drive belt
When starting for very first time after ca. 2 hours of operation, control tension of cog belt
transmitting the drive onto the conditioner or rollers. If cog belt tension is too low, tighten it as per
decal N175.
Operator's manual
- 36 -
Trailed disc mowers
KDC
Fig. 37b. View of properly tightened drive belt