Adjusting Force Of The Pressure Of Roller Conditioner; Maintenance And Service; Checking The Knives And Knife Holders - SaMASZ KDD 860 Operator's Manual

Double-sided mower with central suspension

Hide thumbs Also See for KDD 860:

Table of Contents

6.6. Adjusting force of the pressure of roller conditioner

(Models: KDD 860 W, KDD 940 W, KDD 860 W T and KDD 940 W T)

If need be, the force of roller conditioner's pressure can be regulated by changing the tension

of springs S (Fig. 26) by means of nut N. Adjustment should be done on both sides of the

conditioner.

All knives should have the same lengths and weights. Always check mower before starting

work for damaged, missing and/or worn knives. Replace them, if necessary, only in sets. Make sure

all knives in a set are of the same length and weight.

If the knife holder pin is worn too much and/or the knife holder is worn or deformed, please

replace it immediately (Fig. 27).

CAUTION:

If the knife is missing or disc cover plate is damaged the vibrations may

occur, which leads to cutterbar's damage. In that case, warranty claim

will be revoked. If the disc or disc cover plate is damaged, the whole

set must be immediately replaced (2 knives) with new genuine ones.

Operator's manual

Fig. 26. Adjusting force of the pressure of roller conditioner

Fig. 27. Permissible wear of knife holder pin

Double-sided disc mowers

with central suspension

min.

- 29 -

Table of Contents

Kdd 940 Kdd 860 s Kdd 940 s Kdd 860 w Kdd 940 wKdd 860 s t ... Show all