Dynamic Addressing; Cloning - Xerox WorkCentre 4260 Series System Administration Manual

1. See Chapter 3, Configure Static Addressing using the Machine", "Information
Checklist on page 13.
2. Linux operating system that supports PrintTool.
NOTE:
Procedure
1. Follow the steps in Chapter 3, Configure Static Addressing using the Machine,
Procedure on page 14 until step 38, then return to this page.
Create the Print Queue
1. Open the LPRngTool from the Linux Client.
2. Click on the [Add].
3. In the [Names] area, enter a name for your print queue.
4. The spool directory is the directory where print jobs are stored and is a subdirectory
of [/var/spool/lpd]. Add the name of the print queue to the end of the subdirectory
path.
5. In the [Hostname/IP of Printer] area, enter the hostname or IP Address of the Xerox
machine.
6. Click on [OK].
7. Click on [Exit] to close the program.
8. To allow access to the printer, edit the /etc/hosts table to list the client system.
9. Edit and create the [/etc/hosts.lpd] file to list the client system.

Dynamic Addressing

Information Checklist
See Chapter 3, Configure Dynamic Addressing", "Information Checklist on page 15.
Procedure
1. Follow the steps in Chapter 3, Configure Dynamic Addressing, Procedure on page 16
until step 38, then return to this page.
IMPORTANT: Click on [BOOTP] in step 9.
2. Follow the steps above in Create the Print Queue.

Cloning

Cloning enables you to conveniently copy the settings and scan templates of one machine
and transfer them to another machines with the same system software version. Groups of
settings can be cloned, depending on the optional services installed on the machine. For
example, scan settings will be available for cloning only if the Network Scanning optional
Xerox WorkCentre 4260 Series System Administration Guide
Not all distros of Linux support PrintTool.
Cloning
33