Sco; Information Checklist; Procedure - Xerox WorkCentre 4260 Series System Administration Manual

3 Network Installation
11. Test the queue created, by entering the command:
lp -d queuename /etc/hosts.
12. Verify that the job prints at the machine.
tty Method
1. Enter su to access Super User mode.
2. Enter sh to run the Bourne shell.
3. Define the machine as a BSD style printer, by entering the command:
lpsystem -t bsd hostname
Where hostname is the machine hostname from the /etc/hosts file.
4. Create the queue, by entering the command:
lpadmin -p queuename -s hostname -T unknown -I any
Where queuename is the name of the queue being created.
5. Enter Exit to exit the Bourne shell
6. Enter Exit to exit Super User mode.
7. Test the queue created, by entering the command:
lp -d queuename /etc/hosts.
8. Verify that the job prints at the machine.

SCO

SCO UNIX workstations require specific installation steps to communicate with the
machine. The machines are BSD-style UNIX printers, whereas SCO is a System V-style UNIX.

Information Checklist

Before starting the Installation procedure, please ensure that the following items are
available and/or the tasks have been performed:
1. Existing operational network utilising the TCP/IP protocol.
2. Ensure that the machine is connected to the network.
3. Static IP Address for the machine.
4. Subnet Mask Address for the machine.
5. Gateway Address for the machine.
Host Name for the machine.
6.

Procedure

1. Follow the steps in Chapter 3, Configure Static Addressing using the Machine,
Procedure on page 14 until step 38, then return to this page.
28 Xerox WorkCentre 4260 Series System Administration Guide