Snmp Configuration - Xerox WorkCentre 4260 Series System Administration Manual

3 Network Installation
DHCP/DDNS:
•
Zero-Configuration Networking:
•
•

SNMP Configuration

Allows you to configure the following options when accessing the machine via SNMP.
SNMP Properties:
Enable SNMP v1/v2c Protocols – Allows you to enable or disable the SNMP v1/v2c protocols.
Edit SNMP v1/v2c Properties – Displays the page which allows you to set the following SNMP
v1/v2c properties.
Community Names:
• Community Name (Read Only) – Enter the community name used for display.
Community Name (Read/Write) – Enter the community name used for display and
•
update.
Default Trap Community Name:
• TRAP Community Name – Enter the trap notification community name.
System Administrator's Login ID:
• System Administrator's Login ID – Enter the ID of the System Administrator.
Administrator Account:
• Account Enabled – Select to enable the System Administrator's account.
• User Name – Displays the user name of the System Administrator.
• Authentication Password (minimum 8 characters) – Enter the authentication
password using 8 to 32 characters.
• Confirm Authentication Password – Re-enter the authentication password for
verification.
20
Release Registration – Allows DHCP resources to be released when the machine is
powering down. This is a display-only item and shows "Enabled".
Self Assigned Address (IPv4) – Allocates an IPv4 address without using a DHCP
server. This check box is selected when [IP Address Resolution] is set to [Autonet].
This is a display-only item.
Self Assigned Address (IPv6) – Displays "Enabled". This is a display-only item.
Enable SNMP v3 Protocol – Allows you to enable or disable the SNMP v3
protocol.
Edit SNMP v3 Properties – Displays the page which allows you to set the
following SNMP v3 properties.
This button is active only when the Secure HTTP (SSL) feature is enabled.
Xerox WorkCentre 4260 Series System Administration Guide