15 Security
16.
Follow the steps in Verify that LDAP Authentication is enabled at the machine on
page 137 to check that you have setup authentication correctly.
Configure Network Authentication - Kerberos (Windows ADS)
1.
At your Workstation, open the web browser, enter the TCP/IP Address of the machine
in the Address bar.
2.
Press [Enter].
3.
Click on the [Properties] tab.
4.
Click on the [Security] link.
5.
Click on the [Authentication] link.
6.
Click on the [Authentication] link.
7.
Click on [Require Network Authentication].
8.
To allow guests to access the machine, select the [Allow Guest Access] option and
enter the required [Passcode] for the guest account.
NOTE:
9.
Select the [Kerberos (Windows ADS)] option as the Authentication Type.
10.
Click on [OK].
11.
Enter your Default Realm information in the [Required Information] area.
Enter your Backup Realm information in the [Additional Information] area.
12.
13.
If the [Alternates...] button is available, enter the details of additional alternate
realms the system should use for authentication.
14.
Click on [Always prompt for logoff after each Scan job], in the Logoff Reminder
area, if you want to enable this service.
15.
Click on the [Apply] button to accept the changes.
If prompted, enter the Administrator's User ID [admin] and Password [1111], and
click on [Login].
16.
Follow the steps in Verify that LDAP Authentication is enabled at the machine on
page 137 to check that you have setup authentication correctly.
Configure Network Authentication - SMB (Windows NT 4)
1.
At your Workstation, open the web browser, enter the TCP/IP Address of the machine
in the Address bar.
2.
Press [Enter].
3.
Click on the [Properties] tab.
4.
Click on the [Security] link.
5.
Click on the [Authentication] link.
6.
Click on the [Authentication] link.
134
You cannot leave the Passcode blank.
Xerox WorkCentre 4260 Series System Administration Guide