Internal: During A Break In - Tadiran Telecom FlexSet 280S User Manual

Internal: During a Break In

After dialing a busy destination number and choosing [Brk-In] (see page 29), both conversing parties can hear your
voice. You may press
soft keys.
B TO called name or number
Xfer Mute
[Xfer] Transfer is used to converse in private with the caller party (from the original 2-way call). The called
party is released. (page 166)
[Mute] Mute can be activated during a Break In to mute your side, allowing you to listen to the conversation
but not speak. When this feature is activated by the [Mute] on/off toggle switch, a bullet appears. The
mute feature deactivates the microphone for your speakerphone and handset or headset. Press the toggle
key again to restore the microphone.
[FrcRls] Forced Release enables an authorized user to end the conversation and release two ports actively
connected to each other.
[Dest] Destination is used to converse, in private, with the 3
again for 3-way conversation.
[Source]
Source is used to converse, in private, with the called party. The 3
3-way conversation.
[CallWt]
Calls Waiting can be used to view the number of calls waiting for you during a conversation.
[Number] Number is used to briefly display the two port dial numbers instead of the names.
[Spk/Hs] Speaker/Headset toggles between speaker and the handset operation. (See Using the Speakerphone or
Headset on page 20)
Making Internal Calls
Internal: During a Break In
or hang up in order to allow the continuation of the call, or press on one of the following
SPKR
rd
3 party
FrcRls
Dest Source
rd
party. The called party is put on hold. Press
32
B TO called name or number
rd
3 party
Xfer Mute FrcRls
rd
party is put on hold. Press again for
FlexSet 120S/280S User Guide