Chapter11 Sense Subsystem; Sense:average:count; Sense:time:voltage1; Sense:time:voltage2 - ITech IT8800 Series Programming Manual

The Sense Subsystem is used to configure and control the measurement
functions of the electronic load. A function does not have to be selected before
you program its various configurations. A function can be selected any time
after it has been programmed.

SENSe:AVERage:COUNt

The command is used to specify the filter count. In general, the filter count is
the number of readings that are acquired and stored in the filter buffer for the
averaging calculation. The larger the filter count, the more filtering that is
performed.
Group
Syntax
Arguments
Returns
Example

SENSe:TIME:VOLTage1

SENSe:TIME:VOLTage2

The command sets the output voltage point of the load when measuring the rise
and fall time of voltage output.
Command Syntax
Parameters
Unit
*RST Value
Examples
Query Syntax
MAXimum | DEFault ]
Returned Parameters
Related Commands
SYSTem:SENSe[:STATe] <BOOL>
This command enables or disables remote sense measurement functions.
Group

Chapter11 Sense Subsystem

Sense
SENSe:AVERage:COUNt <NR1>
SENSe:AVERage:COUNt?
2-16
<NR1>
SENSe:AVERage:COUNt 3
SENSe:TIME:VOLTage1 <NRf+>
SENSe:TIME:VOLTage2 <NRf+>
0 through MAX | MINimum | MAXimum | DEFault
V (volts)
MINimum / MAXimum
VOLT:TIME:VOLT1 5
[SOURce:]SENSe:TIME:VOLTage? [ MINimum |
<NR3>
FETC:TIME?
Sense
Copyright © ITECH Electronic Co., Ltd.
Sense Subsystem
59