[Source:]Current:slewrate:state; [Source:]Current:protection:state; [Source:]Current:protection; [Source:]Current:protection:delay - ITech IT8800 Series Programming Manual

[SOURce:]CURRent:SLEWrate:STATe

This command enables or disables the over-current slow rise mode.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands

[SOURce:]CURRent:PROTection:STATe

This command enables or disables the over-current protection feature.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands

[SOURce:]CURRent:PROTection

This command sets the soft current protection level. If the input current exceeds
the soft current protection level for the time specified by CURR:PROT:DEL, the
input is turned off.
NOTE: Use CURR:PROT:DEL to prevent momentary current limit conditions
caused by programmed changes from tripping the overcurrent protection.
Command Syntax
Parameters
Unit
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands

[SOURce:]CURRent:PROTection:DELay

This command specifies the time that the input current can exceed the
protection level before the input is turned off.
Command Syntax
<NRf+>
Parameters
Unit
*RST Value
Examples
Query Syntax
[ MINimum | MAXimum | DEFault ]
[SOURce:]CURRent:SLEWrate[:STATe] <Bool>
0 | 1 | OFF | ON
OFF
CURR:SLEW:STAT 1
[SOURce:]CURRent:SLEWrate:STATe?
<NR3>
CURR:SLEW
[SOURce:]CURRent:PROTection:STATe <Bool>
0 | 1 | OFF | ON
OFF
CURR:PROT:STAT 1
[SOURce:]CURRent:PROTection:STATe?
<NR3>
CURR:PROT
[SOURce:]CURRent:PROTection:LEVel <NRf+>
0 through MAX
A (amperes)
MAXimum
CURR:PROT 2
[SOURce:]CURRent:PROTection:LEVel?
NR3
CURR:PROT:DEL
[SOURce:]CURRent:PROTection:DELay
0 to 60 seconds | MINimum | MAXimum | DEFault
seconds
3
CURR:PROT:DEL 5
[SOURce:]CURRent:PROTection:DELay?
Copyright © ITECH Electronic Co., Ltd.
Source Subsystem
CURR:PROT:STAT
46