[Source:]Resistance:high; [Source:]Resistance:low; [Source:]Resistance:vdrop; [Source:]Resistance:latch[:State] - ITech IT8800 Series Programming Manual

[SOURce:]RESistance:HIGH

[SOURce:]RESistance:LOW

This command sets the high and low level of the voltage when in constant
resistance mode.
Command Syntax [SOURce:]RESistance:HIGH <NRf+>
Parameters
DEFault
Unit
*RST Value
Examples
Query Syntax
[MINimum|MAXimum|DEFault ]
[MINimum|MAXimum|DEFault ]
Returned Parameters

[SOURce:]RESistance:VDRop

This command sets the constant resistance mode of the loads and the LED
cut-off voltage value when LED test function is ON.
Command Syntax [SOURce:] RESistance:VDRop <NRf+>
Parameters
Unit
*RST Value
Examples
Query Syntax
MAXimum | DEFault ]
Returned Parameters
Related Commands

[SOURce:]RESistance:LATCh[:STATe]

This command selects to enable or disable the LED test selection in constant
resistance mode.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands

[SOURce:]POWer

This command sets the power of the load when operating in constant power
mode.
Command Syntax [SOURce:]POWer[:LEVel][:IMMediate] <NRf+>
[SOURce:]RESistance:LOW <NRf+>
MINimum through MAX | MINimum | MAXimum |
V (volts)
MAXimum
RES:HIGH 5
[SOURce:]RESistance:HIGH?
[SOURce:]RESistance:LOW?
<NR3>
0 through MAX | MINimum | MAXimum | DEFault
V (volts)
MINimum
RES:VDR 5
[SOURce:] RESistance:VDRop? [ MINimum |
<NR3>
VOLT:VDR
[SOURce:]VOLTage:LATCh[:STATe] <b>
0 | 1 | ON | OFF
ON
VOLT:LATC 1
[SOURce:]VOLTage:LED[:STATe]?
0 | 1
VOLT:ON
Copyright © ITECH Electronic Co., Ltd.
Source Subsystem
53