[Source:]Protection:clear; [Source:]Current; [Source:]Current:range - ITech IT8800 Series Programming Manual

Examples
Query Syntax
Returned Parameters
Related Commands

[SOURce:]PROTection:CLEar

This command clear the latch that disables the input when a protection
condition such as overvoltage (OV) or overcurrent (OC) is detected. All
conditions that generated the fault must be removed before the latch can be
cleared. The input is then restored to the state it was in before the fault
condition occurred.
Command Syntax
Parameters
Examples

[SOURce:]CURRent

This command sets the current that the load will regulate when operating in
constant current mode.
Command Syntax
<NRf+>
Parameters
Unit
*RST Value
Examples
Query Syntax
[ MINimum | MAXimum | DEFault ]
Returned Parameters
Related Commands

[SOURce:]CURRent:RANGe

This command sets the current range of the electronic load module. There are
two current ranges.
High Range:
Low Range:
When you program a range value, the load automatically selects the range that
corresponds to the value that you program. If the value falls in a region where
ranges overlap, the load selects the range with the highest resolution.
NOTE: When this command is executed, the IMMediate, TRANsient,
TRIGgered, and SLEW current settings are adjusted as follows:
If the existing settings are within the new range:
If the existing settings are outside the new range: The levels are set to the
maximum value of the new range.
Command Syntax
Parameters
Unit
TRAN 1
[SOURce:]TRANsient[:STATe]?
CURR:TRAN:ALEV
None
INP:PROT:CLE
0 through MAX | MINimum | MAXimum | DEFault
A (amperes)
MINimum
CURR 5
[SOURce:]CURRent[:LEVel][:IMMediate]?
model dependent, see Table 4-1
model dependent, see Table 4-1
0 through MAX | MINimum | MAXimum | DEFault
A (amperes)
Copyright © ITECH Electronic Co., Ltd.
0 | 1
CURR:TRAN:CURR:MODE
[SOURce:]PROTection:CLEar
[SOURce:]CURRent[:LEVel][:IMMediate]
CURR:LEV 0.5
<NR3>
CURR:RANG
[SOURce:]CURRent:RANGe <NRf+>
Source Subsystem
44