[Source:]List:slew; [Source:]List:width; [Source:]List:sav; [Source:]List:rcl - ITech IT8800 Series Programming Manual

Related Commands

[SOURce:]LIST:SLEW

This command sets the slew rate for each step. This command programs both
positive and negative going slew rates. MAXimum sets the slew to its fastest
possible rate. MINimum sets the slew to its slowest rate. LIST:SLEW? returns
the number of points programmed.
Command Syntax
Parameters
Unit
Examples
Query Syntax
Returned Parameters <NR3>
Related Commands

[SOURce:]LIST:WIDth

This command sets the time width of each step of a LIST. Each value
represents the time in seconds that the input will remain at the particular list
step point before completing the step. If times exceed 16383S, the input
remains at the present level until a trigger sequences the next point in the list.
Else At the end of the dwell time, the input automatically changes to the next
point in the list.
Command Syntax
Parameters
Unit
Examples
Query Syntax
Returned Parameters

[SOURce:]LIST:SAV

This command stores the present list file of the electronic load to a specified
location in memory. Up to 5 files can be stored. file in saved in locations 1-5 are
volatile, the data are nonvolatile, the data will be saved when power is
removed.
Command Syntax
Parameters
Example
Related Commands

[SOURce:]LIST:RCL

This command restores a list file that was previously stored in memory with a
LIST:SAV command to the specified location.
Command Syntax
Parameters
Example
Related Commands
LIST:RANG
[SOURce:]LIST:SLEW[:BOTH] <NR1> ,<NRf>
1 to steps, MIN to MAX
NONE, NONE
LIST::SLEW1, 1.5
[SOURce:]LIST:SLEW[:BOTH]? <NR1>
CURR:SLEW VOLT:SLEW
[SOURce:]LIST:WIDth <NR1>, <NRf>
1 to steps, 20uS to max
NONE, s (seconds)
LIST:WID 1, 0.02
[SOURce:]LIST:WIDth? <NR1>
<NR3>
[SOURce:]LIST:SAV <NR1>
1 to 7
LIST:SAV 3
[SOURce:]LIST:RCL
[SOURce:]LIST:RCL <NR1>
1 to 7
LIST:RCL 3
[SOURce:]LIST:SAV
Copyright © ITECH Electronic Co., Ltd.
LIST:SLEW 2, MAX
RES:SLEW
LIST:WID 2, 0.5
List Commands
58