[Source:]Power:protection:delay; [Source:]Power:config - ITech IT8800 Series Programming Manual

Note: Use POW:PROT:DEL command to stop the protection of instantaneous
power, which is caused by stopping edit over power protection.
Command Syntax [SOURce:]POWer:PROTection[:LEVel] <NRf+>
Parameters
Unit
*RST Value
Examples
Query Syntax
| MAXimum | DEFault ]
Returned Parameters
Related Commands

[SOURce:]POWer:PROTection:DELay

This command specifies the time that the input power can exceed the
protection level before the input is turned off.
Command Syntax
Parameters
Unit
*RST Value
Examples
Query Syntax
MAXimum | DEFault ]
Returned Parameters
Related Commands

[SOURce:]POWer:CONFig

This command sets the hard power protection level.
Command Syntax
Parameters
Unit
*RST Value
Examples
Query Syntax
MAXimum | DEFault ]
Returned Parameters
Related Commands
0 through MAX | MINimum | MAXimum | DEFault
W (power)
MAXimum
POW:PROT 100
[SOURce:]POWer:PROTection[:LEVel]? [ MINimum
<NR3>
POW:PROT:DEL
[SOURce:]POWer:PROTection:DELay <NRf+>
0 to 60 seconds | MINimum | MAXimum | DEFault
seconds
0
POW:PROT:DEL 5
[SOURce:]POWer:PROTection:DELay? [ MINimum |
<NR1>
POW:PROT
[SOURce:]POWer:CONFig[:LEVel] <NRf+>
0 through MAX | MINimum | MAXimum | DEFault
W (power)
MAXimum
POW:CONFig 100
[SOURce:]POWer:CONFig[:LEVel]? [ MINimum |
<NR3>
POW:PROT
Copyright © ITECH Electronic Co., Ltd.
Source Subsystem
56